Equipment selection center
Find the Right Powder Processing Direction for Your Material
Compare preliminary equipment directions based on your process objective, material state, particle-size target, capacity and handling requirements.
Deterministic preliminary selection guide
Start Equipment Selection
This guide provides a preliminary equipment direction based on the information entered. Final equipment selection, achievable particle size and capacity must be confirmed through technical review and, where necessary, material testing.
Your selections are processed locally in the browser and are not submitted until you choose to contact the sales team.
Comparison overview
Equipment Directions Covered
Hammer Mill
Dry impact milling direction for general dry size reduction.
Conical Mill
Controlled delumping and screen-based granule sizing.
Turbo Sieving Mill
Sieving, classification and deagglomeration direction.
Jet Mill
Fine dry micronization direction for API or fine powders.
Nano Bead Mill
Wet ultra-fine grinding and dispersion direction for slurry or suspension.
High Speed Disperser
Liquid-solid premixing and dispersion direction.
Vertical Basket Mill
Batch wet grinding and dispersion direction.
Melt Extruder
Hot-melt extrusion and continuous thermal compounding direction.
Continuous Granulation System
Continuous granulation and process-section integration direction.
FAQ
Selection Guide Questions
Can this tool select the final machine model?+
No. It provides a preliminary direction only; final selection needs technical review and, where needed, material testing.
Why does material behavior affect equipment selection?+
Hardness, moisture, flowability, heat sensitivity and state can change the suitable process direction.
When should I consider a Hammer Mill?+
For general dry impact size reduction where the material and process direction support it.
When is a Conical Mill more appropriate?+
For controlled delumping or granule sizing where lower-impact processing is preferred.
When is a Jet Mill considered?+
For fine dry micronization after material, gas utility and target requirements are reviewed.
What is the difference between dry and wet grinding?+
Dry milling handles dry powder or granules; wet grinding evaluates slurries or suspensions with formulation considerations.
When is material testing recommended?+
For fine targets, difficult or sensitive materials, high-value materials and scale-up uncertainty.
Can the target particle size be guaranteed?+
No. It must be confirmed through technical review and testing where necessary.
What information is required for a quotation?+
Provide material, feed and target size, capacity, process, safety information and available URS or SDS.
Can you review a URS or SDS?+
Yes. Submit available documents through the existing RFQ route for technical review.
Technical review
Need a Technical Equipment Review?
Share your material, feed size, target particle size, required capacity and available URS or SDS. Our team can review the preliminary equipment direction with you.